Confirmed Fitment
Springfield XDM Magazine Loader
The Springfield XDM is confirmed to fit the Super Thumb ST1, the loader ADCO builds for standard double-stack service-pistol magazines. It loads Springfield XDM magazines faster and with far less thumb strain — a purpose-built tool, not a one-size-fits-all compromise.
Why loading these magazines is a fight
Double-stack magazines get progressively harder to load as the spring compresses — the top few rounds are where thumbs give out. The Super Thumb pushes each round straight down against that spring tension for you, so topping off to full capacity takes seconds instead of sore thumbs.
Your Fit
Super Thumb ST1
Double-Stack
Width
1.29" (32.5 mm)
Height
0.86" (21.9 mm)
Springfield XDM loader — common questions
Which Super Thumb fits the Springfield XDM?
The Springfield XDM is a confirmed fit for the Super Thumb ST1. It appears on ADCO’s verified Super Thumb fit chart as an exact match.
What kind of magazine does the XDM use?
The Super Thumb ST1 is built for standard double-stack service-pistol magazines, which is the class the Springfield XDM uses.
Will the same loader work for my other Springfield pistols?
Often, yes — many Springfield models share the same magazine class. Check the other Springfield fits listed below, or use the Model Finder to confirm your exact model before ordering.
Is the Springfield XDM fit guaranteed?
Every Super Thumb is backed by a lifetime warranty. If you’re not certain, confirm with the Model Finder or call ADCO at 781-935-1799 before you order.
Not 100% sure? Confirm before you order.
Super Thumb loaders are model-specific. Use the Model Finder to double-check your exact firearm and magazine, or call ADCO Arms and we'll confirm the right loader for your Springfield XDM. Every Super Thumb is backed by a lifetime warranty.